Accessing The Device Through Cli; Log Into The Device Using Hyperterminal; Log Into The Device Using Telnet/Ssh - Proxim Tsunami MP-8100 Series Reference Manual

NOTE:
• For dynamic row creation, you have to set the entry status first and then other elements followed by setting the
entry status again.
• Always set the index value to 0 for creating a new dynamic row.
1.2.8.2 Modification of a Table Entry
•
To modify a table entry, you have to mention the Index number.
System Name (config-mon-syslog-hosttbl)#rowedit 1 ipaddress 10.0.0.10
1.2.8.3 Deletion of a Table Entry
•
To delete a table entry, you have to mention the index number.
•
Entry status of the row needed to be destroyed is set to destroy.
System Name(config-mon-syslog-hosttbl)#rowedit 5 entry-status destroy

1.3 Accessing the Device through CLI

You can use the following methods to access the CLI of the unit:

1.3.1 Log into the Device using HyperTerminal

1. Open the terminal emulation program (like HyperTerminal) and set the following connection properties:
• Com Port: <COM1, COM2, etc., depending on your computer>
• Baud rate: 115200
• Data Bits: 8
• Stop bits: 1
• Flow Control: None
• Parity: None
2. Under File > Properties > Settings > ASCII Setup, enable the Send line ends with line feeds option.
HyperTerminal sends a line return at the end of each line of code.
3. Enter the CLI password (default username is admin and password is public).

1.3.2 Log into the Device using Telnet/SSH

To log into the device using Telnet
1. Confirm that your computer's IP address is in the same IP subnet as the device.
2. Go to the DOS command prompt on your computer.
3. Type telnet <IP Address of the unit>.
4. Enter the CLI's default username and password, (default username is admin and password is public).
Tsunami MP-8100 Reference Manual
Command Line Interface
10