Proxim ORiNOCO AP-800 Installation And Management Manual page 142

Spanning Tree Protocol (STP)
To configure STP, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-net)# stp
AP-00:7D:09(config-net-stp)# ?
Possible completions:
bridge-priority
exit
forward-delay
hello-time
max-age
port-table
status
AP-00:7D:09(config-net-stp)# status enable
AP-00:7D:09(config-net-stp)# bridge-priority 4096
AP-00:7D:09(config-net-stp)# max-age 7
AP-00:7D:09(config-net-stp)# forward-delay 5
AP-00:7D:09(config-net-stp)# hello-time 2
AP-00:7D:09(config-net-stp)# exit
AP-00:7D:09(config-net)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show network stp
// STP CONFIGURATION //
STP Status : enable
STP Bridge Priority : 4096
STP Max Age : 7
STP Hello Time : 2
STP Forward Delay : 5
Device Configuration, Management and Monitoring using CLI
STP Bridge Priority Configuration
Exits Back to Global Configure Mode
STP Forward Delay Configuration
STP Hello Time Configuration
STP Max Age Configuration
STP Port Table Configuration
STP Status Configuration
142