Services; Http/Https - Proxim ORiNOCO AP-800 Installation And Management Manual

4.3 Services

The Services feature allows you to configure the management interface (HTTP/HTTPS, Telnet/SSH and SNMP) and SYSLOG
Host Table parameters that prevent from unauthorized access to the device.
To configure the management interface parameters, navigate to MANAGEMENT > Services. The Services screen appears.

4.3.1 HTTP/HTTPS

Configure the following parameters in the HTTP/HTTPS screen:
1. Password: Specifies the password, essential to access the device by using web interface. By default, the password is
set to public. To configure, enter a new password in the Password box. The password should be alphanumeric with
minimum of 6 and maximum of 32 characters.
: Special characters like - = \ " ' ? / space are not allowed in the password.
2. HTTP: Specifies the HTTP status. HTTP allows the user to access the device through a web interface. To configure,
Select Enable or Disable from the drop down menu.
3. HTTP Port: Specifies the port number for the HTTP interface. By default, the port number is 80. To configure, enter a
new HTTP Port.
4. HTTPS: Specifies the HTTPS status. HTTPS allows the user to access the device through a web interface. To configure,
select Enable or Disable from the drop down menu. The password configuration for HTTPS is same as configured for
HTTP.
5. Click OK and then reboot the device for the changes to take effect.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 4-13 HTTP/HTTPS
Device Management Using Web Interface
104