Http Configuration - Proxim ORiNOCO AP-800 Installation And Management Manual

6.7.1.2 Access Table
To configure the Access Table parameters, enter the following CLI commands.

6.7.2 HTTP Configuration

To configure HTTP/HTTPS, enter the following CLI commands.
: To configure the HTTP and HTTPS access status as enable / disable, refer
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-mgmt)# access-table
AP-00:7D:09(config-mgmt)# access-table rowadd 1 ?
Possible completions:
<[Enter]>
entry-status
entry-status-end
(used for TBC)
ipaddress
AP-00:7D:09(config-mgmt)# access-table
AP-00:7D:09(config-mgmt-tbl)# rowadd 0 entry-status 4
Changes in entry status requires reboot.
AP-00:7D:09(config-mgmt-tbl)# rowadd 0 ipaddress 10.0.0.1
Changes in ip address requires reboot.
AP-00:7D:09(config-mgmt-tbl)# rowadd 0 entry-status 4
Changes in entry status requires reboot.
AP-00:7D:09(config-mgmt-tbl)# exit
AP-00:7D:09(config-mgmt)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show access-ctrl
// ACCESS CONTROL CONFIGURATION //
All Access Control : enable
Http Access Control : enable
Https Access Control : enable
Snmp Access Control : enable
Telnet Access Control : enable
SSH Access Control : enable
Mgmt Access Status : disable
// Management Access Table Configuration //
INDEX 1
Ip Address : 10.0.0.1
Status : enable
AP-00:7D:09# configure
AP-00:7D:09(config)# management
AP-00:7D:09(config-mgmt)# http ?
Possible completions:
<[Enter]>
password
' \ / = - space are not valid>
port
AP-00:7D:09(config-mgmt-http)# password public123
Changes in http password requires reboot.
AP-00:7D:09(config-mgmt-http)# port 123
Changes in http port requires reboot.
AP-00:7D:09(config-mgmt-http)#exit
AP-00:7D:09(config-mgmt)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show http
// HTTP CONFIGURATION
Password : ******
Port : 123
Device Configuration, Management and Monitoring using CLI
Execute this command
Entry status for the Management Access Table
Entry status for the Management Access Table
IpAddress Configuration
Execute this command
Password for the HTTP interface<Characters ? "
the port on which HTTP is accessed
//
Access Control
174