Mount The Device - Proxim ORiNOCO AP-800 Installation And Management Manual

2.5.2 Mount the Device

The following considerations must be kept in mind when the device is mounted.
•
The device must be protected from the exposure, and the environmental conditions must be within those specified in
the product datasheet that can be found at http://support.proxim.com.
•
The device uses +5 V/3.5 A power adapter.
:
• Note that the device has been certified under UL Standard 2043 and can be installed in the plenum. In an office building,
plenum is the space between the structural ceiling and the tile ceiling that is provided to help air circulate. Many
companies also use the plenum to house communication equipment and cables. These products and cables must comply
with certain safety requirements, such as Underwriter Labs (UL) and Standard 2043: "Standards for Fire Test for Heat and
Visible Smoke Release for Direct Products and Their Accessories installed in Air-Handling Spaces".
• When installed in a plenum, the device must use PoE
Conduct a site survey to determine the best location for your device. Once you have chosen a location, mount the device to a
wall or a T-bar ceiling as follows:
2.5.2.1 Wall Mounting
1. If the device is powered on, unplug all the power cables.
2. Place the mounting plate on the wall with the embossed inverted letter "L" facing your right.
3. Fasten the mounting plate by using a pair of plastic anchors and screws provided with the Product Package.
4. Hold the device with its rear panel facing up. Next, align two keyholes on the device with the two holders on the
mounting plate.
5. Carefully slide the device down until the holders on the mounting plate fasten securely onto the keyholes of the
device.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 2-3 Mount the Device
Installation and Initialization
21