Simple Network Time Protocol (Sntp) - Proxim ORiNOCO AP-800 Installation And Management Manual

•
Host Comment: Specifies any comment on the SYSLOG Host Table entry.
•
Entry Status: Specifies the entry status set for each table entry. To configure, select either Enable, Disable or
Delete. If Enabled, it allows the device to send SysLog messages to the specified IP address of the SYSLOG server. If
you want to delete any table entry from the SYSLOG Host Table, select Delete.
Click OK, if you have changed the values in the SYSLOG Host Table.
4.3.4.2 Add a new Entry to the SYSLOG Host Table
To add new entries in the SYSLOG Host Table, click Add. The SYSLOG Host Table Add Row screen appears.
1. Configure the following parameters:
•
IP Address: Enter the IP address of the SYSLOG server in the IP Address box.
•
Host Port: Enter a Host Port in the Host Port box. The value ranges from 0 to 65535.
•
Comment: Enter any comments in the Comment box.
2. Click Add.

4.4 Simple Network Time Protocol (SNTP)

SNTP allows you to synchronize the date and time of the device with the configured time servers. When this feature is
enabled, the device will attempt to retrieve the time of day information from the configured time servers (primary or
secondary) and, if successful, will update the relevant time objects in the device. Use the following commands to configure
and view the Simple Network Time Protocol.
To view and configure the SNMP parameters, do the following:
1. Navigate to MANAGEMENT > SNTP. The SNTP screen appears.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 4-19 SYSLOG Host Table Add Row
Figure 4-20 SNTP
Device Management Using Web Interface
110