Commit; Reboot - Proxim ORiNOCO AP-800 Installation And Management Manual

By typing question mark with the show command in the privileged mode, you can get the show command structure and you
can see the possible command's description.

6.6.2 Commit

To apply the changes done, you have to commit those changes before exiting from the configure mode. To do this, use the
following commands before doing an exit from configure mode. Value for commit must be set to 1.

6.6.3 Reboot

For some commands, such as Frequency Domain, Radio Mode and others, it is necessary to commit and reboot the system to
reflect the changes. This can be done by using the reboot command under configure level. For this, follow the procedures
shown below before exiting the configure mode.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09# show ?
Possible completions:
access-ctrl
dhcp
dhcp-database
ethernet
eventlog
eventlog-messages
filtering
hostname
http
inventory
Table
ip
Configuration
learn-table
licensed-feature
network
qos
Rouge-scan
running-config
security
snmp
sntp
ssh
statistics
supported-domains
syslog
syslog-messages
system-information
system-type
tech-support
telnet
text-based-config
tftp
traphost
vlan
vlan-trunk
wireless
AP-00:7D:09> enable
AP-00:7D:09# configure
AP-00:7D:09(config)#commit ?
<value(1)> Apply the changed configurations to the device
AP-00:7D:09(config)# commit 1
AP-00:7D:09> enable
AP-00:7D:09# configure
AP-00:7D:09(config)#reboot ?
Possible completions:
<yes(1)/no(2)> Reboot the device. Set 1 to Reboot
AP-00:7D:09(config)# reboot 1
Device Configuration, Management and Monitoring using CLI
Access Control,Table Configuration
DHCP Configuration
Display the DHCP Server Database
Ethernet Configuration
Eventlog Configuration
Displays the Event log messages
Filtering Configuration
Display the Host Name Information
Http Configuration
Display the Security ID,Inventory Component
Display Ethernet, Wireless Interface IP
Display the Learn Table Information
Display the license feature Information
Network Configuration
QoS Configuration
Rouge Scan
Display All the Running Configuration
Security Configuration
Display SNMP V1,V2-C,V3 Configuration
Sntp Configuration
SSH Configuration
Statistics Monitoring
Displays Supported Frequency Domains List
Display the Syslog,Hosttable Configuration
Displays the System log messages
Display the System Information
Display the System Type table, Network Mode
Display Technical Support Information
Telnet Configuration
Show text-based-config
Tftp Configuration
Display the Trap Host table information
Vlan & Vlan Ethernet Configuration
Vlan Trunk Table Configuration
Wireless Status and Configuration
137