Proxim ORiNOCO AP-800 Installation And Management Manual page 161

Profile Table Configuration
To configure Profile table parameters do the following
6.6.4.8 VLAN
To configure VLAN parameters, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-qos)# profile-table
AP-00:7D:09(config-qos-profile)# ?
AP-00:7D:09(config-qos-profile)# rowedit 1 ?
Possible completions:
<[Enter]>
edca-profile-name
nack-status
policy-name
AP-00:7D:09(config-qos-profile)# rowedit 1 edca-profile-name Default
AP-00:7D:09(config-qos-profile)# rowedit 1 policy-name Default
AP-00:7D:09(config-qos-profile)# rowedit 1 nack-status disable
AP-00:7D:09(config-qos-profile)# exit
AP-00:7D:09(config-qos)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show qos profile
// QoS PROFILE TABLE CONFIGURATION //
INDEX 1
Profile Name : Default
Policy Name : Default
Edca Profile Name: Default
Nack Status : disable
AP-00:7D:09(config)# vlan
AP-00:7D:09(config-vlan)# ?
Possible completions:
config-table
exit
mgmt-vlan-id
mgmt-vlan-priority
radius-vlan-status
trunk-table
vlan-status
AP-00:7D:09(config-vlan)# vlan-status enable
AP-00:7D:09(config-vlan)# radius-vlan-status enable
AP-00:7D:09(config-vlan)# mgmt-vlan-id 1
AP-00:7D:09(config-vlan)# mgmt-vlan-priority 2
AP-00:7D:09(config-vlan)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show vlan
// VLAN CONFIGURATION //
Vlan Status : enable
MgmtVLAN ID : 1
MgmtVlan Priority : 2
Radius VLAN Status : enable
// VLAN Ethernet Configuration //
INDEX 1
Vlan Mode
Access VLAN ID
Access Vlan Priority
Allow Untagged Frames
Device Configuration, Management and Monitoring using CLI
:
Execute this command
EDCA Profile Name Configuration
Nack Status Configuration
Policy Name Configuration
Vlan Config Table Configuration
Exits Back to Global Configure Mode
Management VLAN IDentifier
Management VLAN priority
Radius VLAN Status
VLAN trunk parameters for ethernet interface
Configure the VLAN functionality
: trunk
: -1
: 0
: disable
161