Proxim ORiNOCO AP-800 Installation And Management Manual page 140

Ethernet IP Configuration
To configure the Ethernet IP, enter the following CLI commands.
Default Gateway Configuration
To configure the Default Gateway, enter the following CLI commands.
: If you have changed any of the TCP/IP parameters, then reboot the device.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-net-ip)# ethernet-ip-table
AP-00:7D:09(config-net-ip-etherip)# rowedit 1 ipaddress 10.0.0.1
Changes in Ethernet IP Address requires reboot.
AP-00:7D:09(config-net-ip-etherip)# rowedit 1 mask 255.255.255.0
Changes in Ethernet Subnet mask requires reboot.
AP-00:7D:09(config-net-ip-etherip)# rowedit 1 address-type static
Changes in Ethernet IP Address Type requires reboot.
AP-00:7D:09(config-net-ip-etherip)#exit
AP-00:7D:09(config-net-ip)#exit
AP-00:7D:09(config-net)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show ip
// Ethernet IP CONFIGURATION //
INDEX 1
Ip Address : 10.0.0.1
Mask : 255.255.255.0
Address Type : static
// IP Gateway CONFIGURATION//
Gateway IP Address : 169.254.128.1
AP-00:7D:09(config-net-ip)# default-gateway 10.0.0.1
Changes in Default Route Address requires reboot.
AP-00:7D:09# show ip
// Ethernet IP CONFIGURATION //
INDEX 1
Ip Address : 10.0.0.1
Mask : 255.255.255.0
Address Type : static
// IP Gateway CONFIGURATION//
Gateway IP Address : 10.0.0.1
Device Configuration, Management and Monitoring using CLI
140