Vlan Ethernet Configuration - Proxim ORiNOCO AP-800 Installation And Management Manual

•
Management VLAN Priority: Specifies the IEEE 802.1p priority set for the management frames. By default, it is
set to 0. To configure, set the VLAN priority within the range of 0 to 7.
3. Click OK, to save the configured parameters.
:
• When VLAN is enabled, ensure that all nodes in the network share the same VLAN ID as this will ensure that all the
Access Points are managed easily.
• In the case of RADIUS Server Authentication or EAP Authentication, if the RADIUS Server is present on any VLAN, then
the RADIUS Server should be the member of management VLAN ID of the device.

3.7.1 VLAN Ethernet Configuration

To enable VLAN on the ethernet interface, do the following:
1. Navigate to CONFIGURATION > VLAN > Ethernet. The VLAN Ethernet Configuration screen appears.
2. Configure the following parameters:
•
Interface: Specifies a read-only parameter that represents the interface on which VLAN is configured.
•
VLAN Mode: Specifies the VLAN mode to be configured on the ethernet interface. You can configure any of the
following VLAN modes on the ethernet interface.
a. Transparent Mode: Transparent Mode is configurable on the ethernet interface of the device. It is equivalent
to NO VLAN support and is the default mode. It is used to connect VLAN aware/unaware networks. An
interface in transparent mode forwards both tagged and untagged frames. To configure this VLAN mode on
the ethernet interface, select Transparent Mode from the VLAN Mode box and click OK.
b. Access Mode: Access Mode is configurable on the wireless, ethernet and management interfaces of the
device. This mode is used to connect VLAN aware networks with VLAN unaware networks. In Access Mode,
tagged frames with specified Access VLAN ID going out of the device through the interface are untagged and
forwarded. The untagged frames coming into the device through the interface are tagged with specified
Access VLAN ID and forwarded.
To configure this VLAN mode on the ethernet interface, select Access Mode from the VLAN Mode box and
click OK. The configuration screen appears:
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-33 VLAN Ethernet Configuration
Device Configuration Using Web Interface
74