Proxim ORiNOCO AP-800 Installation And Management Manual page 143

STP Port Table:
To configure the STP Port table parameters, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-net-stp)# port-table
AP-00:7D:09(config-net-stp-port-tbl)# rowedit 1 priority 16
AP-00:7D:09(config-net-stp-port-tbl)# rowedit 1 path-cost 5
AP-00:7D:09(config-net-stp-port-tbl)# rowedit 1 status disable
AP-00:7D:09(config-net-stp-port-tbl)# exit
AP-00:7D:09(config-net-stp)# exit
AP-00:7D:09(config-net)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show network stp
// STP CONFIGURATION //
STP Status : enable
STP Bridge Priority : 4096
STP Max Age : 7
STP Hello Time : 2
STP Forward Delay : 5
// STP PORT TABLE //
INDEX 1
Status : disable
VAP Name : ath0
Port State : forwarding
Port Priority : 16
Port Path Cost : 5
INDEX 2
Status : enable
VAP Name : wds1
Port State : disabled
Port Priority : 128
Port Path Cost : 4
INDEX 3
Status : enable
VAP Name : ath2
Port State : disabled
Port Priority : 128
Port Path Cost : 4
INDEX 4
Status : enable
VAP Name : ath3
Port State : disabled
Port Priority : 128
Port Path Cost : 4
INDEX 5
Status : enable
VAP Name : ath4
Port State : disabled
Port Priority : 128
Port Path Cost : 4
INDEX 6
Status : enable
VAP Name : ath5
Port State : disabled
Port Priority : 128
Port Path Cost : 4
INDEX 7
Status : enable
VAP Name : ath6
Port State : disabled
Port Priority : 128
Port Path Cost : 4
INDEX 8
Status : enable
VAP Name : ath7
Port State : disabled
Port Priority : 128
Port Path Cost : 4
Device Configuration, Management and Monitoring using CLI
143