Proxim ORiNOCO AP-800 Installation And Management Manual page 149

11n-Properties Configuration
To configure the 11n properties, enter the following CLI commands for interface 1 and interface 2.
:
• If AMPDU status is enabled and the operational mode is set to either 11na or 11ng, then fragmentation (See
Configuration) is not configurable.
• Reboot the device, if you have configured any rebootable parameters.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09# configure
AP-00:7D:09(config)# wireless
AP-00:7D:09(config-wireless)# dot11n-Properties
AP-00:7D:09(config-wireless-11n-Prop)# ?
Possible completions:
exit
radio
AP-00:7D:09(config-wireless-11n-Prop)# radio ?
Possible completions:
1
<value (1-2)>
AP-00:7D:09(config-wireless-11n-Prop)# radio 1
Possible completions:
<[Enter]>
ampdu-max-frame-size
ampdu-max-frames
ampdu-status
frequency-extension
AP-00:7D:09(config-wireless-11n-prop)# radio 1 ampdu-max-frames 50
AP-00:7D:09(config-wireless-11n-prop)# radio 1 ampdu-max-frame-size 1500
AP-00:7D:09(config-wireless-11n-prop)# radio 1 ampdu-status 1
AP-00:7D:09(config-wireless-11n-prop)# radio 1 frequency-extension 2
Changes in Frequency Extension requires reboot.
AP-00:7D:09(config-wireless-11n-prop)# exit
AP-00:7D:09(config-wireless)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show wireless 11n-properties
// 11n-PROPERTIES CONFIGURATION //
INTERFACE 1
ampdu Status
ampdu Maximum Number of Frames : 50
ampdu Maximum Frame Size
Frequency Extension
INTERFACE 2
Ampdu Status
Ampdu Maximum Number of Frames : 64
Ampdu Maximum Frame Size
Frequency Extension
Device Configuration, Management and Monitoring using CLI
Exits Back to Global Configure Mode
Radio Index Configuration
Radio Index Configuration
Radio Index Configuration
Execute this command
Configure the maximum AMPDU frame size
Aggregated MAC Protocol Data Unit frame
AMPDU Status Configuration
Frequency Extension Configuration
: enable
: 1500
: LowerExtension Channel
: enable
: 65535
: UpperExtension Channel
VAP
149