Proxim ORiNOCO AP-800 Installation And Management Manual page 163

6.6.4.9 Filters
To configure the filters, enter the following CLI commands.
Global Filter Flag
To configure the Global Filters, enter the following CLI commands.
STP Frame Status
By default, the system will not accept all the STP frames passing through a node. To configure and enable STP Frames, enter
the following CLI commands.
Intra-BSS Configuration
To configure the Intra-BSS filter, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config)# filtering
AP-00:7D:09(config-filter)# ?
Possible completions:
advanced
exit
global-filter-control
intra-bss
packet-forwarding
protocol
proxy-arp-status
security-gateway
staticmac
storm-threshold
stp-frame-status
tcpudp
AP-00:7D:09(config-filter)# global-filter-control disable
AP-00:7D:09(config-filter)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09 # show filtering global-filter-control
Global Filter Flag : disable
AP-00:7D:09(config-filter)# stp-frame-status enable
AP-00:7D:09(config-filter)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09#show filtering stp-frame-status
// STP FRAME STATUS CONFIGURATION //
STP Frame Status
AP-00:7D:09(config-filter)# intra-bss disable
AP-00:7D:09(config-filter)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show filtering intra-bss
Intra BSS : disable
Device Configuration, Management and Monitoring using CLI
Advanced Filter Table Configuration
Exits Back to Global Configure Mode
Global Filter Control Configuration
Intra BSS Configuration
Packet Forwarding Configuration
Protocol Filter Type,Filter Control,Table
Proxy ARP status
Security Gateway Configuration
Static Mac Address Table Configuration
Storm Threshold Configuration
STP Frame Forward status
TCP UDP Port Filter Control,Table Configuration
: enable
163