D To 802.1P Mapping Table; Qos Profile - Proxim ORiNOCO AP-800 Installation And Management Manual

2. Configure the following parameters:
•
802.1d to IP DSCP Index: Specifies a read-only parameter which indicates the IP DSCP index corresponding to
802.1d priority.
•
Lower Limit and Upper Limit: Specifies the IP DSCP range (lower and Upper limit) for each 802.1d priority. To
configure, enter the Lower Limit and Upper Limit in the range of 0 to 63, respectively for each 802.1d priority.
3. Click OK, to save the configured parameters.

3.6.3 802.1d to 802.1p Mapping Table

To configure priority mapping between QoS 802.1d and 802.1p (for layer 2 policies) do the following:
1. Navigate to CONFIGURATION > QoS > 802.1d to 802.1p Map Tbl. The 802.1d to 802.1p Mapping Table screen
appears.
2. Configure the following parameters:
•
802.1d Priority: Specifies a read-only parameter which represents the 802.1d priority.
•
802.1p Priority: Specifies the 802.1p priority mapped to the corresponding 802.1d priority. To configure, enter
the 802.1p Priority, for the corresponding 802.1d priority, in the range of 0 to 7.
3. Click OK, to save the configured parameters.

3.6.4 QoS Profile

To configure QoS Profile parameters, do the following:
1. Navigate to CONFIGURATION > QoS > QoS Profile. The QoS Profile screen appears.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-27 802.1d to 802.1p Mapping Table
Figure 3-28 QoS Profile
Device Configuration Using Web Interface
69