Ip Configuration - Proxim ORiNOCO AP-800 Installation And Management Manual

3.2.1 IP Configuration

The IP Configuration feature enables you to configure the TCP/IP settings of the device on a network.
To configure TCP/IP parameters of the device, do the following:
1. Navigate to CONFIGURATION > Network > IP Configuration. The Network IP Configuration screen appears.
2. Configure the following parameters:
•
Address Type: By default this parameter is set to Dynamic. When set to dynamic, the device will obtain IP settings
from a network Dynamic Host Configuration Protocol (DHCP) server automatically during the boot-up. If you do
not have a DHCP server or if you want to manually configure the device IP address, set this parameter to Static.
•
IP Address: Specifies the IP Address of the device. When the address type is set to Dynamic, this parameter is
read-only and displays the device current IP address obtained from the DHCP server. The device will default to
169.254.128.132, if the device cannot obtain the IP address from a DHCP server. If the Address Type is set to
Static then you will have to manually enter the IP Address in the IP Address box.
•
Subnet Mask: Specifies the device subnet mask. When the address type is set to Dynamic, this parameter is
read-only and displays the device current subnet mask obtained from the DHCP server. The subnet mask will
default to 255.255.0.0, if the device cannot obtain the subnet mask from a DHCP server. If the Address Type is set
to Static then you will have to manually enter the subnet mask in the Subnet Mask box.
•
GateWay IP Address: Specifies the IP address of the device gateway. When address type is set to Dynamic, this
parameter is read-only and displays the IP address of the device gateway. The gateway IP address will default to
169.254.128.133, if it cannot obtain the gateway IP address from a DHCP server. If the Address Type is set to
Static then you will have to manually enter the gateway IP address in the GateWay IP Address box.
•
Primary IP Address: Specifies the IP Address of the Primary DNS Server. When the address type is set to Dynamic,
this parameter is read-only and displays the DNS Primary IP Address obtained from the DHCP server. If the Address
Type is set to Static then you will have to manually enter the IP Address in the Primary IP Address box.
•
Secondary IP Address: Specifies the IP Address of the Secondary DNS Server. When the address type is set to
Dynamic, this parameter is read-only and displays the DNS Secondary IP Address obtained from the DHCP server. If
the Address Type is set to Static then you will have to manually enter the IP Address in the Secondary IP Address
box.To save the configured parameters, click OK.
3. Click OK, to save the configured parameters.
: If you have changed any of the TCP/IP parameters, then reboot the device.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-3 Network IP Configuration
Device Configuration Using Web Interface
38