Syslog And Host Table - Proxim ORiNOCO AP-800 Installation And Management Manual

6.7.7 Syslog and Host Table

Enter the following commands to configure Syslog and Host table:
To display the system log messages, use the following command:
AP-00:7D:09# show syslog-messages
To clear the system log messages, see
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-mgmt-syslog)# ?
Possible completions:
exit
host-table
priority
reset
status
AP-00:7D:09(config-mgmt-syslog)# priority emergency
AP-00:7D:09(config-mgmt-syslog)# status enable
AP-00:7D:09(config-mgmt-syslog)# reset no
AP-00:7D:09(config-mgmt-syslog)# host-table rowadd 1 ?
Possible completions:
<[Enter]>
comment
entry-status
entry-status-end
ipaddress
port
AP-00:7D:09(config-mgmt-syslog-hosttbl)# rowadd 0 entry-status create
AP-00:7D:09(config-mgmt-syslog-hosttbl)# rowadd 0 ipaddress 10.0.0.1
AP-00:7D:09(config-mgmt-syslog-hosttbl)# rowadd 0 port 514
AP-00:7D:09(config-mgmt-syslog-hosttbl)# rowadd 0 comment firstrow
AP-00:7D:09(config-mgmt-syslog-hosttbl)# rowadd 0 entry-status create
AP-00:7D:09(config-mgmt-syslog-hosttbl)#exit
AP-00:7D:09(config-mgmt-syslog)#exit
AP-00:7D:09(config-mgmt)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show syslog
// SYSLOG CONFIGURATION //
Status : enable
Priority : emergency
Reset : no
// HOST TABLE CONFIGURATION //
INDEX 1
Ip Address : 10.0.0.1
Port : 514
Comment : firstrow
Entry status : enable
Clear Statistics
Device Configuration, Management and Monitoring using CLI
Exits Back to Global Configure Mode
Host Table Configuration
Configure the priority for the syslog
reset/clear the syslog
Status for the sysLog
Execute this command
Comment for the host port of the syslog table
Entry Status Configuration
Entry Status Configuration(Used for TBC)
IP for which syslog messages to be sent
Port for which syslog messages to be sent
178