Proxim ORiNOCO AP-800 Installation And Management Manual page 165

TCP UDP Table
To configure the TP UDP table parameters, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-filter)# tcpudp
AP-00:7D:09(config-filter-tcpudp)# ?
Possible completions:
exit
port-filter-ctrl
tcpudp-table
AP-00:7D:09 (config-filter)#tcpudp port-filter-ctrl disable
AP-00:7D:09 (config-filter-tcpudp)#tcpudp-table
AP-00:7D:09 (config-filter-tcpudp-tbl)#tcpudp-table
AP-00:7D:09 (config-filter-tcpudp-tbl)#rowadd 0 entry-status create
AP-00:7D:09 (config-filter-tcpudp-tbl)#rowadd 0 port-number
AP-00:7D:09 (config-filter-tcpudp-tbl)#rowadd 0 protocol-name
AP-00:7D:09 (config-filter-tcpudp-tbl)#rowadd 0 port-type tcp
AP-00:7D:09 (config-filter-tcpudp-tbl)#rowadd 0 interface 1
AP-00:7D:09 (config-filter-tcpudp-tbl)#rowadd 0 entry-status create
AP-00:7D:09 (config-filter-tcpudp-tbl)#exit
AP-00:7D:09 (config-filter-tcpudp)#exit
AP-00:7D:09 (config-filter)#exit
AP-00:7D:09 (config)#exit
AP-00:7D:09# show filtering tcpudp
// TCP UDP FILTERS CONFIGURATION//
Port Filter Control: disable
INDEX 1
Protocol Name : NetBios-Name-Service
Port Number : 137
Port Type : both
Interface : allinterfaces
Entry status : disable
INDEX 2
Protocol Name : NetBios-Datagram-Service
Port Number : 138
Port Type : both
Interface : allinterfaces
Entry status : disable
INDEX 3
Protocol Name : NetBios-Session-Service
Port Number : 139
Port Type : both
Interface : allinterfaces
Entry status : disable
INDEX 4
Protocol Name : SNMP-service
Port Number : 161
Port Type : both
Interface : allinterfaces
Entry status : disable
INDEX 5
Protocol Name : IPSEC/ISAKMP
Port Number : 500
Port Type : both
Interface : allinterfaces
Entry status : disable
INDEX 6
Protocol Name : L2TP
Port Number : 1701
Port Type : both
Interface : allinterfaces
Entry status : disable
Device Configuration, Management and Monitoring using CLI
Exits Back to Global Configure Mode
Port Filter Control Configuration
TCP UDP Table Configuration
80
HTTP
165