Proxim ORiNOCO AP-800 Installation And Management Manual page 53

•
Fragmentation Threshold: The process of dividing a MAC Service Data Unit (MSDU) into smaller MAC level
frames for transmission over the wireless network is called Fragmentation. This reduces both the probability and
adverse effects of wireless packet corruption, and thereby improving the overall wireless network performance.
You can fragment the Unicast receiver address, whereas Broadcast/Multicast frames cannot be fragmented, even
though they exceed a fragmentation threshold. If the size of the data packet is more than the configured value,
AP breaks the data into pieces called Fragments and transmits. Each fragment size is the Fragmentation Threshold.
By default, the Fragmentation Threshold is set to 2346 bytes. To configure, enter a value ranging from 256 to
2346 bytes in the Fragmentation Threshold box.
: In 11n mode, if AMPDU is enabled then Fragmentation Threshold will not be configurable.
•
Security Profile Name: This parameter allows you to select the Security profile name for the wireless VAP. Click
the Security Profile Name box and select the security profile. By default, the available Security Profile Name is
"AP Security". (Refer
•
RADIUS Profile Name: Specifies the RADIUS profile name for the wireless VAP. Click the RADIUS Profile Name
box and select the RADIUS profile. By default, the available RADIUS Profile name is "Default RADIUS". Refer
RADIUS
•
VLAN ID: Specifies the VLAN ID for the wireless VAP. By default, the VLAN ID is set to -1 which means that VLAN
tag is disabled. To enable VLAN tag, enter a value ranging from 1 to 4094 in the VLAN ID box.
•
VLAN Priority: Specifies the VLAN priority for the Wireless VAP. To configure this parameter, enter a value ranging
from 0 to 7 in the VLAN Priority box. By default the value is set to 0.
: To configure the VLAN ID and VLAN Priority for a VAP, VLAN status should be enabled. (See
Area Network
•
QoS Profile Name: Specifies the QoS profile name for the Wireless VAP. You can configure the QoS Profile name
as either Default or NONE. To configure this parameter, enter the QoS profile name in the QoS Profile Name box.
QoS Profile.
See
:
• If the QoS Profile Name is defined as NONE, then by default the QoS feature will be disabled.
• By default, QoS Profile Name is taken as NONE for legacy mode. It can be manually enabled by changing it
to Default QoS Profile.
•
Local MAC Authentication: This parameter is used to either enable or disable the local MAC Access Control list.
Click Local MAC Authentication box to either enable or disable its status.
•
RADIUS MAC Authentication: This parameter is used to either enable or disable the MAC Access Control for
RADIUS Profiles. Click the RADIUS MAC Authentication box to either enable or disable its status.
: If you have enabled Local MAC Authentication, then do not enable RADIUS MAC Authentication.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Wireless Security)
(VLAN))
Device Configuration Using Web Interface
Virtual Local
53