2. Configure the following parameters:
•
Filtering Control: Specifies the parameter, used to configure the interface on which filtering has to be applied. By
default, it is disabled. It can be configured as:
— Ethernet: Packets are examined at the ethernet interface.
— Wireless: Packets are examined at the wireless interface.
— All interfaces: Packets are examined at both ethernet and wireless interface.
To set Filtering Control on an interface, select an interface from the Filtering Control drop down menu.
•
Filtering Type: Specifies the action to be performed on the data packets whose protocol type is not defined in
the protocol filter table (this table contains a list of default protocols supported by the device and the protocols
defined by the user), or whose Entry Status is in Disable state. The available filtering types are:
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-38 Protocol Filters
Device Configuration Using Web Interface
78