Proxim ORiNOCO AP-800 Installation And Management Manual page 152

6.6.4.5 Security
To configure security parameters, enter the following CLI commands.
Wireless Security
Add and Edit a wireless - security profile
To add or edit a wireless - security profile, enter the following CLI commands.
To edit the wireless - security profile parameters in different authentication modes, enter the following CLI commands.
802.1x Security
To configure the 802.1x authentication mode, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09>enable
AP-00:7D:09# configure
AP-00:7D:09(config)# security
AP-00:7D:09(config-sec)# ?
Possible completions:
exit
macacl
radius
security-profile
AP-00:7D:09(config)# security security-profile ?
Possible completions:
<[Enter]>
rowadd
entry.
row.
rowedit
AP-00:7D:09(config)# security security-profile
AP-00:7D:09(config-sec-tbl)# rowadd 0 ?
Possible completions:
<[Enter]>
authentication-mode
encryption-type
entry-status
entry-status-end
key-1
profile-name
psk
rekey-interval
NOTE:
1.The symbols equal(=), Double Quotes("), Single Quotes('), Back Slash(\),
Forward Slash(/), Question Mark(?), Hyphen(-) and Blank Space are invalid
for configuring Passwords and Keys.
2.For WDS,TKIP/AES encryption types will accept only 16 Ascii characters
or 32 Hex digits.
AP-00:7D:09(config-sec)# security-profile
AP-00:7D:09(config-sec-tbl)# rowadd 0 entry-status create
AP-00:7D:09(config-sec-tbl)# rowadd 0 profile-name dot1x_sec
AP-00:7D:09(config-sec-tbl)# rowadd 0 authentication-mode dot1x
AP-00:7D:09(config-sec-tbl)# rowadd 0 encryption-type wpa2-aes
AP-00:7D:09(config-sec-tbl)# rowadd 0 rekey-interval 904
Rekeying Interval is configurable only in AP mode.
AP-00:7D:09(config-sec-tbl)# rowadd 0 entry-status create
Device Configuration, Management and Monitoring using CLI
Exits Back to Global Configure Mode
MAC-ACL Configuration
Radius Configuration
Wireless Security Configuration
Execute this command
Enter 0 or available index to create a new table
The available index is next to the existing last
Edit/Delete Wireless Security Table Entry
Execute this command
Authentication Mode Configuration
Encryption Type Configuration
Entry Status Configuration
Entry Status Configuration(Used for TBC)
Encryption Key 1 Configuration
<Characters ? " ' \ / = - space are not valid>
Security Profile Name Configuration
<Characters ? " ' \ / = - space are not valid>
Pre-Shared Key Configuration
Rekeying Interval Configuration
152