Proxim ORiNOCO AP-800 Installation And Management Manual page 75

Configure the following parameters in Access Mode:
• Access VLAN Id: Specifies an Access VLAN ID. By default, it is taken as -1. A value of -1 indicates no
• Access VLAN Priority: Specifies the IEEE 802.1p priority set for the frames. By default, it is taken as 0.
Click OK, to save the configured parameters.
c. Trunk Mode: Trunk Mode is configurable on the ethernet interface of the device. It is mainly used to connect
VLAN aware networks with VLAN aware networks. An interface in the Trunk mode only forwards those
tagged frames whose VLAN ID matches with a VLAN ID present in trunk table. All other frames will be
dropped.
To configure this VLAN mode on the ethernet interface, select Trunk Mode from the VLAN Mode box and
click OK. The configuration screen appears:
Configure the following additional parameters in Trunk Mode:
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-34 VLAN Access Mode
tag is added to the frame. To configure, enter the Access VLAN ID either as -1 or a value ranging from
1 to 4094.
To configure, enter a value ranging from 0 to 7.
Figure 3-35 Trunk Mode
Device Configuration Using Web Interface
75