Proxim ORiNOCO AP-800 Installation And Management Manual page 146

6.6.4.4 Wireless
Properties
To configure the wireless properties, enter the following CLI table parameters in Interface 1 and Interface 2.
:
• To view the country code in the wireless interface properties, refer
• Reboot the device, if you have configured any rebootable parameters.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09>enable
AP-00:7D:09# configure
AP-00:7D:09(config)# wireless
AP-00:7D:09(config-wireless)# properties ?
Possible completions:
<[Enter]>
radio
AP-00:7D:09(config-wireless)# properties radio ?
Possible completions:
1
<value (1-2)>
AP-00:7D:09(config-wireless-properties)# radio 1 ack-timeout 100
AP-00:7D:09(config-wireless-properties)# radio 1 auto-channel-selection 2
/ When Auto channel is enabled, ignore current configured channel/
AP-00:7D:09(config-wireless-properties)# radio 1 beacon-interval 100
AP-00:7D:09(config-wireless-properties)# radio 1 cellsize large
AP-00:7D:09(config-wireless-properties)# radio 1 configured-channel 36
AP-00:7D:09(config-wireless-properties)# radio 1 country-code ?
Possible completions:
<Use command 'show supported-domains' for supported country codes>
Country Code Configuration
AP-00:7D:09(config-wireless-properties)# radio 1 country-code 201
Change in Country code requires reboot.
AP-00:7D:09(config-wireless-properties)# radio 1 current-bandwidth 20
/Changes in current channel Bandwidth will reset the TX rate to default
value./
Changes in current channel Bandwidth requires reboot.
AP-00:7D:09(config-wireless-properties)# radio 1 dtim 3
AP-00:7D:09(config-wireless-properties)# radio 1 operational-mode
802.11a/n
Changes in operational-mode requires reboot.
AP-00:7D:09(config-wireless-properties)# radio 1 radio-status 1
AP-00:7D:09(config-wireless-properties)# radio 1 rts-threshold 2346
AP-00:7D:09(config-wireless-properties)# radio 1 tpc 0
AP-00:7D:09(config-wireless-properties)# radio 1 antenna-gain 12
AP-00:7D:09(config-wireless-properties)# radio 1 high-power-mode disable
AP-00:7D:09(config-wireless-properties)# radio 1 link-distance 600
AP-00:7D:09(config-wireless-properties)# radio 1
all-channel-scan
AP-00:7D:09(config-wireless-properties)# radio 1 Rouge-scan-period 1000
AP-00:7D:09(config)# wireless properties radio 1 wds-optimization-mode
enable
AP-00:7D:09(config-wireless-properties-radio-1)# exit
AP-00:7D:09(config-wireless-properties)# exit
AP-00:7D:09(config-wireless)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show wireless properties
Device Configuration, Management and Monitoring using CLI
Device Configuration
Execute this command
Radio Index Configuration
Radio Index Configuration
Radio Index Configuration
Rouge-scan-status
146