Proxim ORiNOCO AP-800 Installation And Management Manual page 90

3. Click OK, if you have changed any of the DHCP server parameters.
3.9.1.1 DHCP Interface Settings
The DHCP Interface Settings Table contains the following information:
1. Net Mask: Specifies the subnet mask to be sent to the client along with the assigned IP address. The netmask
configured here should be greater than or equal to the netmask configured on the interface. To configure, enter the
Net Mask.
2. Default Gateway: Specifies the default gateway to be sent to the client along with the assigned IP Address. Default
Gateway is a node that serves as an accessing point to another network. To configure, enter the Default Gateway
address.
3. Primary DNS: Specifies the primary DNS (Domain Name Server) IP address to be sent to the client. To configure, enter
the Primary DNS address.
4. Secondary DNS: Specifies the secondary DNS IP address to be sent to the client. To configure, enter the Secondary
DNS address.
5. Default Lease Period: Specifies the least time offered by the DHCP server, to the client on that interface. By default,
it is taken as 86400 seconds. To configure, enter a value ranging from 3600 to 172800 seconds.
6. Status: Specifies the status of DHCP server functionality over the interface. By default, it is disabled. To configure,
select Enable or Disable from the drop down menu.
7. Click OK, to save the configured parameters.
3.9.1.2 DHCP Pool Table
The DHCP Pool Table contains the following information:
1. Start IP Address: Specifies the Start IP Address of the pool.
2. End IP Address: Specifies the End IP Address of the pool.
3. Delete: This parameter allows you to delete the added pool entry.
4. Click OK, if you have changed any of the DHCP Pool parameters.
:
• To enable DHCP Server, atleast one pool must be configured for it.
• A pool entry can be deleted but not edited.
3.9.1.3 Add an Entry to DHCP Pool Table
To add an entry to the DHCP Pool Table, click Add in the DHCP Server screen. The DHCP Pool Table Add Row screen
appears.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-49 DHCP Pool - Add an Entry
Device Configuration Using Web Interface
90