Configuring The Device Using Cli; Show Command - Proxim ORiNOCO AP-800 Installation And Management Manual

6.6 Configuring the Device using CLI

The Command Line Interface (CLI) is divided into different command modes. Each command mode has its own set of
commands that manage the network operations. The commands that you use also depend on the mode that you are in. To
configure the device parameters in Global Configuration mode use 'configure' under Priviledge mode and then type ? to list
the available commands.
To proceed with configuration, select each interface and enter the required parameters and their configurations.

6.6.1 Show Command

When you enter show command along with ? at the CLI command prompt, it lists the following feature that you can
configure or view.
When you execute show command in user mode, you will get few commands only. But in privileged mode, all available
commands under show are displayed and can be executed.You can execute show command only when you are in user mode
or privileged mode, but not in Global configuration mode.
AP-00:7D:09# show ?
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09>enable
AP-00:7D:09# configure
AP-00:7D:09(config)# ?
Possible completions:
commit
dhcp
exit
filtering
management
monitor
network
qos
radio-mode
Reboot
security
vlan
wireless
AP-00:7D:09> show ?
Possible completions:
hostname Display the Host Name Information
ip Display Ethernet, Wireless Interface IP Configuration
licensed-feature Display the license feature Information
system-information Display the System Information
tech-support Display Technical Support Information
Device Configuration, Management and Monitoring using CLI
Apply the changed configurations to the device
DHCP Configuration
Exit from configure mode
Filtering Configuration
Management Configuration
Monitor Configuration
Network Configuraion
Quality of Service Configuration
Radio Mode Configuration
Reboot the device.Set 1 to reboot
Security Configuration
Vlan Configuration
Wireless Configuration
136