•
TSLF: Specifies the time period since the last frame has been received (TSLF) over the channel. It is recorded in dd
: hh : mm : ss (days: hours: minutes: seconds)
•
RSSI: Specifies the strength of the signal received by the detected device. The signal strength detected by the
radio of the device, varies between the values 0 - 128. The higher the value, the greater is the received signal
strength.
3. Click Refresh, to view the updated Rouge Scan Statistics.
4. Click Clear, to clear the Rouge Scan Statistics.
5.4 Bridge
The device serves as a bridge between the wired and the wireless networking devices.
5.4.1 Bridge Statistics
The Bridge Statistics allows you to monitor the statistics of the Bridge.
1. To view bridge statistics, navigate to MONITOR > Bridge > Bridge Statistics. The Bridge Statistics screen appears.
2. The Bridge Statistics screen contains the following information:
•
Description: Specifies the description about the bridge.
•
Type: Specifies the type of interface.
•
MTU: Specifies the largest size of the data packet sent on the bridge.
•
Physical Address: Specifies the MAC address at the bridge protocol layer.
•
Operational Status: Specifies the current operational status of the bridge.
•
In Octets: Specifies the total number of octets received on the bridge.
•
In Unicast Packets: Specifies the number of unicast subnetwork packets delivered to the higher level protocol.
•
In Non-Unicast Packets: Specifies the number of non-unicast subnetwork packets delivered to the higher level
protocol.
•
In Errors: Specifies the number of inbound packets with errors and that are restricted from being delivered.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 5-6 Bridge Statistics
Device Monitoring Using Web Interface
119