Update Configuration - Proxim ORiNOCO AP-800 Installation And Management Manual

2. Click TFTP.
3. Configure the following parameters:
•
Server IP Address: Specifies the IP Address of the TFTP server. To configure, enter the Server IP Address.
•
File Name: Specifies the name of the updated firmware file (including the file extension) that has to be
downloaded onto the device. To configure, enter the File Name with extension.
4. To update the device with new firmware, click either Update, or Update & Reboot. If you click Update, then you
should reboot the device after downloading the files. Whereas, if you click Update and Reboot, the system will
automatically reboot the device after downloading the files.
:
• After upgrading the device with the new firmware, reboot the device; Otherwise the device will continue to run with the
old firmware.
• It is recommended not to navigate away from the update screen, while the update is in progress.

4.2.2 Update Configuration

4.2.2.1 Update Configuration By Using HTTP
To update the device with configuration files using HTTP, do the following:
1. Navigate to MANAGEMENT > File Management > Update Configuration. The Update Configuration screen
appears.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 4-5 Update Firmware by using TFTP
Device Management Using Web Interface
97