Add A New Entry To The Access Control Table; Reset To Factory - Proxim ORiNOCO AP-800 Installation And Management Manual

4.5.1 Add a new Entry to the Access Control Table

To add new entries to the Access Control Table, click Add in the Management Access Control Table screen. The
Management Access Table Add Row screen appears. Note that you can add new entries only when the Access Table status
is enabled.
1. Configure the following parameters:
•
IP Address: Enter the IP address of the machine that would manage the device, in the IP Address box.
•
Entry Status: By default the entry status is enabled.
2. Click Add.
: Applicable only to SNMP v1-v2c.You can enter a maximum of five IP addresses to manage the device.

4.6 Reset to Factory

The Reset to Factory feature allows you to reset the device to its factory default state. When this operation is performed, the
device will reboot automatically and comes up with default configurations.
To reset the device to its factory defaults, do the following:
1. Navigate to MANAGEMENT > Reset To Factory. The Factory Reset screen appears.
2. Then, Click OK for the device to restart with the default factory configuration.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 4-22 Management Access Control - Add Row
Figure 4-23 Reset to Factory
Device Management Using Web Interface
112