Proxim ORiNOCO AP-800 Installation And Management Manual page 45

2. Configure the following parameters:
•
Radio Status: Specifies the status of the radio of the AP device. By default, the radio status is enabled. To disable,
select Disable from the Radio Status box. If the radio status is disabled, the interface gets shutdown.
•
Radio Mode: This parameter enables you to set the radio mode of the device. The available radio mode is AP.
•
Country Code: Specifies the country where the device will be used. To configure this parameter, select a country
from the Country Code box.
:
• Country selection is available only on APs with model numbers ending in -WD. Setting the country makes the
AP automatically compliant with the rules of the regulatory domain in which it is used, by configuring the
allowed frequency bands, channels, Dynamic Frequency Selection, Transmit Power Control, and power levels.
• If the country is not selected, an informational message will appear on the Status page, and you will be unable
to configure interface parameters. APs in which, country selection is not available on the system tab, the
regulatory domain is pre-programmed into the AP prior to shipment.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-9 Wireless Interface-1 Properties
Device Configuration Using Web Interface
45