Snmp - Proxim ORiNOCO AP-800 Installation And Management Manual

4.3.3 SNMP

Configure the following parameters in the SNMP screen:
1. SNMP: Select Enable or Disable from the drop down menu. If enabled, it allows the user to access the device
through the SNMP Interface.
: Any change in the SNMP access will affect the NMS access.
2. Version: Specifies the parameter that allows you to configure the SNMP version. The available SNMP versions are
v1-v2c and v3. By default, the SNMP starts in version v2c.
•
If you select the SNMP version as SNMP v1-v2c, the following parameters need to be configured.
— Read Password: Specifies the parameter that provides read access to device by using SNMP interface. The
default password is "public". To configure, enter a new password in the Read Password box. The password
should be alphanumeric with minimum of 6 and maximum of 32 characters.
— Read/Write Password: Specifies the parameter that provides read/write access to device using SNMP
interface. The default password is "public. To configure, enter a new password in the Read/Write Password
box. The password should be alphanumeric with minimum of 6 and maximum of 32 characters.
•
If you select the SNMP version as SNMP v3, then following parameters need to be configured.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 4-15 SNMPv1-v2c
Device Management Using Web Interface
106