Proxim ORiNOCO AP-800 Installation And Management Manual page 156

MAC ACL Address Table
6.6.4.7 Qos Configuration
To configure the QoS parameters, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config)# security
AP-00:7D:09(config-sec)#macacl
AP-00:7D:09(config-sec-macacl)# address-table
AP-00:7D:09(config-sec-macacl-address)# rowadd 1 secondary-index 0
entry-status 4
AP-00:7D:09(config-sec-macacl-address)# rowadd 1 secondary-index 0 comment
firstrow
AP-00:7D:09(config-sec-macacl-address)# rowadd 1 secondary-index 0
mac-address 00:11:22:33:44:55
AP-00:7D:09(config-sec-macacl-address)# rowadd 1 secondary-index 0
entry-status 4
AP-00:7D:09(config-sec-macacl-address)#exit
AP-00:7D:09(config-sec-macacl)#exit
AP-00:7D:09config-sec)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show security macacl address-table
// MAC ACL ADDRESS TABLE CONFIGURATION //
INDEX 1.1
MAC Address : 00:11:22:33:44:55
Comment : firstrow
Entry Status : enable
AP-00:7D:09>enable
AP-00:7D:09# configure
AP-00:7D:09(config)# qos
AP-00:7D:09(config-qos)# ?
Possible completions:
dot1p-mapping-table
edca-table
exit
ipdscp-mapping-tble
policy-table
profile-table
Device Configuration, Management and Monitoring using CLI
DOT1D To DOT1P Mapping Configuration
Edca Table Configuration
Exits Back to Global Configure Mode
IPDSCP Mapping Table Configuration
Policy Table Configuration
Profile Table Configuration
156