Filters - Proxim ORiNOCO AP-800 Installation And Management Manual

• Allow Untagged Frames: To configure, either select Enable or Disable from the drop down menu. If
Click OK, to save the configured parameters.
To add new Trunk Table Entries, click Add. The VLAN Trunk Table Add Row screen appears.
Configure the following parameters to Add a new Trunk Table Entry:
— Trunk Id: Specifies the Trunk Id. To configure, enter the Trunk Id value ranging from 1 to 4094. The
maximum Trunk Ids that you can create are 256.
— Entry Status: Specifies the status of the entry being added. To configure, select either Enable or Disable
from the drop down menu.
Click Add, to save the configured parameters.

3.8 Filters

The Packet Filter feature helps you to control the amount of traffic exchanged between the wired and wireless networks. By
using filters, you can restrict any unauthorized packets from accessing the network.
To configure Filters on the device, do the following:
1. Navigate to CONFIGURATION > Filters. The Filters screen appears.
2. Configure the following parameters:
•
Global Filter Flag: Specifies the global filter on the device. By default, it is disabled on the device. To configure,
select Enable or Disable from the drop down menu.
: If the Global Filter Flag is not enabled on the device, then none of the filters can be applied.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
enabled, an interface in Trunk mode forwards both tagged frames whose VLAN ID matches with one
of the VLAN IDs in the trunk table and untagged frames. If disabled, an interface in Trunk mode
forwards only tagged frames and drops untagged frames.
Figure 3-36 Add New Trunk Table Entries
Device Configuration Using Web Interface
Figure 3-37 Filters
76