Proxim ORiNOCO AP-800 Installation And Management Manual page 56

Figure 3-14 (a) VAP in WDS - Legacy Mode
5. Configure the following parameters:
•
Type: Specifies the type of the VAP configured. (VAP Type may be in AP, WDS-Legacy or WDS END-A/END-B)
: The AP device performs the standard AP fuctionality, if the VAP type is selected to AP mode (See
•
Status: Specifies the status of the VAP. By default, the Status is enabled. To disable, select Disable from the drop
down menu.
•
BSSID: Specifies a read-only parameter which displays the VAP MAC address.
•
Peer MAC Address: Specifies the MAC Address of the destination VAP.
•
Security Profile Name: Specifies the Security profile name for the wireless VAP. By default, the Security Profile
Name taken is AP Security. To configure, click the Security Profile Name box and select the security profile.
•
QoS Profile Name: Specifies the QoS profile name for the Wireless VAP. The QoS Profile name taken is Default.
QoS Profile).
(See
: By default, the QOS profile name is set to NONE, for legacy mode. It can be manually enabled to Default
QoS Profile.
6. Click OK, to save the configured changes.
:
• All the eight VAPs on an interface, can be enabled in WDS mode.
• WDS does not support the Dynamic Frequency Selection (DFS).
• The nodes participating in establishment of a WDS link on either sides, should be configured with same channel and
security settings.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Device Configuration Using Web Interface
Figure 3-14 4 (b) VAP in WDS - 11n Mode
AP Mode)
56