Proxim ORiNOCO AP-800 Installation And Management Manual page 169

Proxy ARP Status: To configure Proxy ARP, enter the following CLI commands.
Storm Threshold Configuration
Enter the following commands to configure Storm Threshold.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09 (config-filter)#advanced
AP-00:7D:09(config-filter-advanced)# rowedit 1 direction ethernet2wireless
AP-00:7D:09(config-filter-advanced)# rowedit 1 entry-status enable
AP-00:7D:09(config-filter-advanced)#exit
AP-00:7D:09(config-filter)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show filtering advanced
// ADVANCED FILTER TABLE CONFIGURATION
INDEX 1
Protocol Name : Deny-IPX-RIP
Direction : ethernet2wireless
Entry Status : enable
INDEX 2
Protocol Name : Deny-IPX-SAP
Direction : both
Entry Status : disable
INDEX 3
Protocol Name : Deny-IPX-LSP
Direction : both
Entry Status : disable
INDEX 4
Protocol Name : Deny-IP-Broadcasts
Direction : both
Entry Status : disable
INDEX 5
Protocol Name : Deny-IP-Multicasts
Direction : both
Entry Status : disable
AP-00:7D:09(config)# filtering
AP-00:7D:09(config-filter)# proxy-arp-status enable
AP-00:7D:09(config-filter)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show filtering proxy-arp-status
// PROXY ARP STATUS CONFIGURATION //
Proxy ARP Status
AP-00:7D:09(config)# filtering
AP-00:7D:09(config-filter)# storm-threshold
AP-00:7D:09(config-filter-storm-thresh)# rowedit 1 broadcast-threshold 200
AP-00:7D:09(config-filter-storm-thresh)# rowedit 1 multicast-threshold 150
AP-00:7D:09(config-filter-storm-thresh)# exit
AP-00:7D:09(config-filter)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show filtering storm-threshold
// STORM THRESHOLD FILTER TABLE CONFIGURATION //
INDEX 1
Interface : ethernet
Multicast Threshold : 150
Broadcast Threshold : 200
INDEX 2
Interface : wireless1
Multicast Threshold : 0
Broadcast Threshold : 0
INDEX 3
Interface : wireless2
Multicast Threshold : 0
Broadcast Threshold : 0
Device Configuration, Management and Monitoring using CLI
: enable
169