Proxim ORiNOCO AP-800 Installation And Management Manual page 46

•
Operational Mode: This parameter determines the communication mode between the AP device and the
wireless client(s).
By default, the Operational Mode for Interface 1 (Radio1) is set to 802.11a/n for AP-8000 and is set to 802.11g/n
for AP-800. However, you can also configure the operational mode for Interface 1 in either 802.11a, 802.11g or
802.11g/n modes.
: For the JP (Japan) SKU, the Interface 1 (Radio1) of AP-8000, can be configured only in 5GHz frequency
band, that is in 802.11a or 802.11a/n modes.
•
Current Bandwidth: Specifies the frequency band used to transmit wireless data. The available bandwidths are
20 MHz and 40 MHz. By default, the device operates in 40MHz. To set the bandwidth for the wireless data
transmission, select a value from the Current Bandwidth box.
: Set the current bandwidth to 20 MHz, to enable the legacy operational modes of 802.11a or 802.11g.
When the Current Bandwidth is set to 40 Mhz and the extension channel is busy, the AP
device operates with channel bandwidth of 20 Mhz only (Dynamic 20/40 channel bandwidth
mode), to avoid unnecessary retries at a higher rate. Once the extension channel is available,
the device will switch back to the channel bandwidth of 40 MHz. See
if a VAP is enabled in WDS mode.
•
Channel Selection: This parameter enables the device to determine the best channel for wireless data
transmission with less interference. By default, Auto Channel Selection is disabled. To enable, select Enable
from the Auto Channel Selection box.
When this parameter is enabled in AP Mode, the device scans all the available channels and selects the best
channel to establish a connection.
: When the device detects RADAR on the current operating Channel, the Auto Channel Selection gets
enabled automatically even though it is disabled by the user.
•
Current Active Channel: When the Auto Channel Selection is enabled, this parameter displays the current active
channel of the wireless interface.
•
Current Operating Channel: When the Auto Channel Selection is disabled and the Radio Mode is set to AP, then
this parameter is applicable. This parameter enables the user to select the current operating channel for the
wireless interface.
To configure this parameter, select current operating channel for the wireless interface from the Current
Operating Channel box. Note that, when you select the channel, its corresponding frequency is displayed on the
right-side of the drop-down box.
•
RTS Threshold: Enter a value ranging from 1 to 2346 in the RTS Threshold box. If the size of the MPDU is of the
specified threshold value or greater, then the device uses the RTS mechanism for data transmission. When set to
2346 (the default setting), RTS is disabled.
•
Beacon Interval: Specifies the interval between two successive beacons. By default, the value is set to 100ms. To
configure beacon interval for AP, enter a value ranging from 100 to 1000ms in the Beacon Interval box.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Device Configuration Using Web Interface
WDS Optimization Mode,
46