View Leds; Install The Cable Security Cover (Optional) - Proxim ORiNOCO AP-800 Installation And Management Manual

2.5.5 View LEDs

When the device is powered on, it performs startup diagnostics. When startup is complete, the LEDs show the operational
state of the device.
The top panel of the device contains four LED indicators.
1. When power is applied to the device, you will observe that Power LED lights up Green.
2. The color of the Ethernet LED indicates the speed of the Ethernet traffic:
RED : 100 Mbps
GREEN : 1000 Mbps
OFF : No link is available or Ethernet is not connected
3. When in operational status, the Wireless LED will be in steady green. The wireless LEDs would blink green when the
wireless traffic is being transmitted or received.
: The LEDs glow orange when the device initializes.

2.5.6 Install the Cable Security Cover (Optional)

When the RS-232 cable is not connected, install a cable security cover, to prevent the Power, LAN ports, reset and reload
buttons from getting tampered.
Follow the following procedure to install the Cable Security Cover:
•
Open the split end of the security cover just enough to slide the power cable (if the Gigabit Ethernet PoE is not used)
and the CAT6 Ethernet cable through the opening until they fit inside the straight clamping portion of the cover.
Exercise care as you slide the cable (s) so you do not accidently break the cover.
•
Slide the hinging end of the security cover and insert the latch into the hole at the rear end of the device.
•
Insert the two screws into the screw holes near serial port and fasten the security cover on the device.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 2-4 LED Indicators
Installation and Initialization
23