Mac Access Control - Proxim ORiNOCO AP-800 Installation And Management Manual

•
IP Address: Specifies the IP address of the RADIUS server configured. To configure, enter the IP Address in the
box.
•
Server Port: Specifies the port number, which the device and the server use to communicate. To configure, enter
the Server Port number in the box.
•
Shared Secret: Specifies the password shared by the RADIUS server and the device. To configure, enter a Shared
Secret in the box.
•
Entry Status: Specifies the status of the RADIUS server. By default, the first RADIUS Server is enabled. To
configure, select Enable or Disable from the drop down menu.
4. Click OK, to save the configured parameters of the RADIUS Server Profile.

3.5.3 MAC Access Control

The MAC Access Control feature of the device allows only the authorized wireless stations to access the network. MAC
Authentication is supported only on the wireless interface.
To configure MAC Access Control parameters, do the following:
1. Navigate to CONFIGURATION > Security > MAC ACL. The MAC Access Control screen appears.
2. Configure the following parameters:
•
Operation Type: Specifies the two types of operations, Allow or Deny.
— Allow: Allows only the wireless stations in the MAC Access Control Table to access the wireless network.
— Deny: Does not allow the wireless stations in the MAC Access Control Table to access the wireless network.
By default, the Operation Type taken is Deny. To configure, select Allow from the drop down menu.
3. Click OK, to save the Operation Type parameters configured.
: To enable MAC Access Control, you should enable Local MAC Authentication in VAP.
3.5.3.1 Add Wireless Stations to MAC Access Control Table
To add a MAC address of a wireless station in the MAC Access Control Table, click Add in the MAC Access Control screen.
The MAC ACL Add Row screen appears.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-22 MAC Access Control
Device Configuration Using Web Interface
64