Proxim ORiNOCO AP-800 Installation And Management Manual page 86

3.8.4.1 TCP/UDP Port Filter Table
The TCP/UDP Port Filters screen displays a list of default protocols supported by the device and the protocols created by the
user. By default, the system generates seven protocols entries. Each of the Protocol contains the following information:
1. Protocol Name: Specifies the Protocol name.
: The system throws an error when you try to edit the name of a default protocol.
2. Port Number: Specifies the TCP/UDP port number.
: The system throws an error when you try to edit the Port number of a default protocol.
3. Port Type: Specifies the type of the port. Select the port type as TCP/UDP/Both from the Port Type box. By default,
Port Type is Both for the default entries and TCP for the newly added entries.
4. Filter Interface: Specifies the parameter used to configure the interface on which the Filter is applied. Select the
interface as either Only Ethernet, Only Wireless, or All Interfaces from the Filter Interface box.
5. Entry Status: Set the entry status as Enable/Disable/Delete.
– Enable: The device filters the TCP/UDP protocols.
– Disable: The device allows all the TCP/UDP protocols.
– Delete: The device deletes a protocol entry from the Filter Table.
: System-defined default protocols entries cannot be deleted.
6. To save the configured parameters, click OK.
3.8.4.2.1 Add New Entries to TCP/UDP Port Filter Table
To add user-defined protocols to the TCP/UDP Port Filter Table, do the following:
1. Click Add in the TCP/UDP Port Filters screen. The TCP/UDP Port Filter Add Row screen appears.
.
2. Provide details for all the parameters and click Add.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-45 TCP/UDP Port Filter Table - Add Entries
Device Configuration Using Web Interface
86