Proxim ORiNOCO AP-800 Installation And Management Manual page 72

1. Navigate to CONFIGURATION > VLAN. The VLAN screen appears.
2. Configure the following parameters:
•
VLAN Status: Specifies the status of the VLAN on the device. By default, it is disabled. To enable VLAN, check the
VLAN Status box.
: To configure the Wireless (VAP) VLAN properties and Ethernet VLAN properties, VLAN status should be
enabled.
•
Radius VLAN Status: This parameter enables VLAN assignment to AP stations through a RADIUS Server. This way
of RADIUS based VLAN assignment helps:
— To reduce the task of manually configuring VLAN parameters on each station connected to the AP device.
— The station to remain on the same VLAN as it moves across the network.
— To maintain a maximum number of groups/stations under a single VAP network.
— To reduce the interference by sending the traffic to intended groups/stations.
Following figure and explanation illustrates the work process of RADIUS based VLAN assignment:
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-30 VLAN
Figure 3-31 RADIUS based VLAN Re- assignment
Device Configuration Using Web Interface
72