Managing The Device Using Cli Commands; Access Control And Access Table Configuration - Proxim ORiNOCO AP-8000 User Manual

Using CLI to Manage the Access Point

Managing the Device Using CLI Commands

vlan {
status: disable
vlan-id: -1
}
Network Configuration
The IP Subnet Mask of the AP must match your network's Subnet Mask.
(config)#dev-configure
(config-dev<config>)#network
(config-dev<config>-net)#index 1 ipaddress 10.0.0.1
(config-dev<config>net)#index 1 mask 255.255.255.0
(config-dev<config>net)#index 1 gateway 169.254.128.133
(config-dev<config>net)#index 1 address-type static
Show command for Network configuration
Device-Name# show configure network
// RUNNING-CONFIGURATION //
// Network Configuration //
network
ipaddress: 192.168.9.41
mask: 255.255.255.0
gateway: 192.168.9.1
address-type: static
}
Managing the Device Using CLI Commands

Access control and access table configuration

You can configure the following management services:
Device-Name(config-mgmt)# access-ctrl
Device-Name(config-mgmt-access<ctrl>)#access-status enable
Device-Name(config-mgmt-access<ctrl>)#http-access-ctrl enable
Device-Name(config-mgmt-access<ctrl>)#https-access-ctrl enable
Device-Name(config-mgmt-access<ctrl>)#ssh-access-ctrl enable
Device-Name(config-mgmt-access<ctrl>)#telnet-access-ctrl enable
Device-Name# show management access-control
// RUNNING-CONFIGURATION //
// Access Control Configuration //
accesscontrol {
http-access-control: enable
httpsaccesscontrol: enable
snmp-access-control: enable
telnet-access-control: enable
ssh-access-control: enable
mgmt-access-status: disable
}
// Management Access Table Configuration //
{
AP-8000 User Guide
132