Global Configuration Mode; Miscellaneous; Tbc - Proxim ORiNOCO AP-800 Installation And Management Manual

6.4.3 Global Configuration Mode

In this mode, you can configure your device. Use the 'configure' command to enter this mode.
Example:
AP-00:7D:09# configure
AP-00:7D:09(config)#
This brings the CLI into a special mode called "Global Configuration Mode", where full access permissions are given to the
user for configuring any available configuration of the device through CLI. The command prompt of this mode uses an
interactive hierarchical format which shows the configuration level the user is in and with its name.

6.5 Miscellaneous

This section describes about various miscellaneous commands used in the device.

6.5.1 TBC

6.5.1.1 Generate
Text Based Configuration (TBC) file is a simple text file that holds the template configurations of the device. The device
supports the TBC file in XML format which can be edited in any XML or text editors.
Text Based Configuration file can be generated by using generate command. The TBC file can be generated with or without
passwords or also with keys. The TBC file contains the default configurations as well as the configurations made by the user
on that live CLI session. For configurations made on the live CLI session, you must use entry-status-end command instead of
entry-status command while finishing the creation of row.
TBC config file with password
TBC config file without password
6.5.1.2 Load
All configurations in the TBC file can be loaded to the device using the load command. Loading the TBC file is allowed only
once in an active device session (that is, if TBC file is loaded, commit to apply all configurations or to load another TBC file
reboot is required to save the configurations of all the rebootable parameters). All configurations in the TBC file are loaded to
the device irrespective of their default or modified or added configurations.The process of loading the TBC file takes
approximately 10 to 20 seconds depending on the number of configurations present in the TBC file.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09# generate tbc-with-pwds
Text Based Config Generated Successfully.
AP-00:7D:09# generate tbc-without-pwds
Text Based Config Generated Successfully.
AP-00:7D:09# load tbc-file
Loading Configuration(s) from File --- Please Wait....
TBC file loaded successfully. Please commit to save the changes (Refer
syslogs for error info)
Device Configuration, Management and Monitoring using CLI
135