Spanning Tree Protocol (Stp) - Proxim ORiNOCO AP-800 Installation And Management Manual

•
Link Status: Specifies connectivity status between a server and a device. Link Status can either be UP, DOWN or
NONE.
— UP: Specifies the Link Status when the AP device receives the server(s) acknowledgment.
— DOWN: Specifies the Link Status when the AP device does not receive server(s) acknowledgment.
— NONE: Specifies the Link Status when the AP device is trying to connect to the server(s) that is when the Link
Status is neither UP nor DOWN.
3. Click OK, to save the configured parameters.
3.2.2.1 Link Integrity Server Configuration Table
The Link Integrity Server Configuration Table displays the details of all the pre-configured server(s), as follows:
•
Server IP Address: Specifies the IP Address of the configured server.
•
Comment: Specifies the user comment of the configured server.
•
Entry Status: Specifies the entry status of the server. By default, it is disabled. To configure, set the entry status as
Enable/Disable/Delete from the drop down menu.
— Enable: Enables the server added.
— Disable: Disables the server added.
— Delete: Deletes the server added.
Click OK, to save the configured parameters.
Link Integrity Table - Add Row
To enable link integrity on the AP device, atleast one entry should be added to the Link Integrity Server Configuration
Table. A maximum of five servers can be added. To add an entry, do the following:
1. Click Add in the link integrity screen, the Link Integrity Table - Add Row screen appears:
2. Configure all the parameters and click Add, to save the added entry.

3.2.3 Spanning Tree Protocol (STP)

The Spanning Tree Protocol (STP) helps to avoid the bridged loops and ensures a loop-free topology for bridged LAN
(connected on both Wireless (WDS) and Ethernet interface).
Following is the step-by-step procedure on how STP feature works:
a. Disable: In this state, STP is disabled and no traffic is allowed through Wireless and Ethernet interfaces of the bridged
LAN.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-5 Link Integrity Table - Add Row
Device Configuration Using Web Interface
40