Trap Host Table - Proxim ORiNOCO AP-800 Installation And Management Manual

6.7.6 Trap Host Table

To configure the SNMP Trap Host Table parameters, enter the following CLI commands.
: Password configuration is only applicable to the SNMP version of snmpv1-v2c.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-mgmt)# trap-host-table
AP-00:7D:09(config-mgmt)# trap-host-table rowadd 1 ?
Possible completions:
<[Enter]>
comment
entry-status
entry-status-end
ipaddress
password
AP-00:7D:09(config-mgmt-trap)# rowadd 0 entry-status 4
Changes in entry-status requires reboot.
AP-00:7D:09(config-mgmt-trap)# rowadd 0 ipaddress 10.0.0.50
Changes in ip requires reboot.
AP-00:7D:09(config-mgmt-trap)# rowadd 0 comment Test_Box
Changes in comment requires reboot.
AP-00:7D:09(config-mgmt-trap)# rowadd 0 password test123
Changes in password requires reboot.
Configuring this command for v3 is not valid.
AP-00:7D:09(config-mgmt-trap)# rowadd 0 entry-status 4
Changes in entry-status requires reboot.
AP-00:7D:09(config-mgmt-trap)#exit
AP-00:7D:09(config-mgmt)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show traphost
// TRAP HOST TABLE CONFIGURATION //
INDEX 1
Ip Address : 169.254.128.133
Password : ******
Comment : Default
Entry Status : enable
INDEX 2
IP Address : 10.0.0.50
Password : ******
Comment : Test_Box
Entry Status : enable
Device Configuration, Management and Monitoring using CLI
Execute this command
Comment Configuration
Entry Status Configuration
Entry Status Configuration (Used for TBC)
Ip Configuration
Only Applicable in SNMP v2.
<Characters ? " ' \ / = - space are not valid>
177