Proxim ORiNOCO AP-800 Installation And Management Manual page 59

a. None: If you select this Authentication Mode, then no security exists on the wireless network.
b. WEP (Wired Equivalent Privacy): Select WEP from the Authentication mode drop down menu and the
configuration screen appears:
Configure the following parameters in WEP mode:
• Key: This parameter allows you to configure the WEP key for the wireless security. Enter a WEP Key in the Key
box.
— For 64-bit encryption, an encryption key is 10 hexadecimal characters (0-9 and A-F) or 5 ASCII characters.
See
— For 128-bit encryption, an encryption key is 26 hexadecimal characters or 13 ASCII characters.
— For 152-bit encryption, an encryption key is 32 hexadecimal characters or 16 ASCII characters.
: Special characters like - = \ " '? / space are not allowed while configuring the WEP key.
c. PSK (Pre-shared Key): Select PSK from the Authentication mode drop down menu and the configuration
screen appears:
Configure the following parameters in PSK mode:
• Encryption Type: Specifies the Encryption Type. By default, it is taken as WPA-TKIP. To configure, enter the
Encryption Type as either WPA-TKIP, WPA2-AES or WPA-WPA2AES-TKIP from the drop down menu.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-17 WEP Authentication Mode
ASCII Character Chart.
Figure 3-18 PSK Authentication Mode
Device Configuration Using Web Interface
59