Proxim ORiNOCO AP-800 Installation And Management Manual page 139

6.6.4.2 Network
To configure the Network Parameters, enter the following CLI commands.
Perform the following commands to configure the IP settings. Configuration changes in IP settings takes effect only after
commit and reboot. You can commit and reboot the device using the Commit and Reboot commands.
IP Configuration
To configure the IP, enter the following CLI commands.
Primary DNS, Secondary DNS, and Supported Interfaces
Supported Interfaces Scalar is a read-only parameter, and it displays the interface names that are supported on the device
depending upon the Network Mode (Bridge/Router) in which the device is running. To configure Primary/Secondary Domain
Name Servers on the device, use the following commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config)# network
AP-00:7D:09(config-net)# ?
Possible completions:
clear-interface-stats
exit
ip
link-integrity
stp
AP-00:7D:09(config-net)# ip
AP-00:7D:09(config-net-ip)#?
Possible completions:
default-gateway
interfaces
ethernet-ip-table
exit
primary-dns-ip
secondary-dns-ip
AP-00:7D:09(config)# network
AP-00:7D:09(config-net)# ip
AP-00:7D:09(config-net-ip)# primary-dns-ip 172.18.18.23
AP-00:7D:09(config-net-ip)# secondary-dns-ip 169.234.127.12
AP-00:7D:09(config-net-ip)# exit
AP-00:7D:09(config-net)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show network netconfig
// NETWORK CONFIGURATION //
All Interfaces Default Router Address
Supported Interfaces
Primary DNS Ip Address
Secondary DNS IP Address
Device Configuration, Management and Monitoring using CLI
Clear Interface Statistics
Exits Back to Global Configure Mode
Ethernet/Wireless Ip Configuration
link integrity Configuration
STP Configuration
Default Router Address that applies to all
Ethernet Ip Configuration
Exits Back to Global Configure Mode
Primary DNS IP Address Configuration
Secondary DNS IP Address Configuration
: 192.168.2.1
: br0
: 172.18.18.23
: 169.234.127.12
139