VLAN config table
VLAN can operate in different modes based on the incoming traffic. To configure the VLAN Ethernet parameters, enter the
following CLI commands.
Access Mode
Transparent Mode
Trunk Mode
VLAN Trunk Table
The following commands are used to configure the VLAN Trunk table. It is configurable only in bridge mode.
For Ethernet Interface.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-vlan)# config-table
AP-00:7D:09(config-vlan-configtbl)# rowedit 1 vlan-mode access
AP-00:7D:09(config-vlan-configtbl)# rowedit 1 access-vlan-id 23
AP-00:7D:09(config-vlan-configtbl)# rowedit 1 access-vlan-priority 3
AP-00:7D:09(config-vlan-configtbl)# exit
AP-00:7D:09(config-vlan)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show vlan
// VLAN CONFIGURATION //
Vlan Status
: enable
MgmtVLAN ID
: 234
MgmtVlan Priority
: 0
Radius VLAN Status : enable
//
VLAN Ethernet Configuration //
INDEX 1
Vlan Mode
Access VLAN ID
Access Vlan Priority
Allow Untagged Frames
AP-00:7D:09(config-vlan-configtbl)# rowedit 1 vlan-mode ?
Possible completions:
<transparent(1)/access(2)/trunk(3)>
AP-00:7D:09(config-vlan-configtbl)# rowedit 1 vlan-mode 1
AP-00:7D:09(config-vlan-configtbl)# rowedit 1 vlan-mode trunk
AP-00:7D:09(config-vlan-configtbl)# rowedit 1 untagged-frames enable
AP-00:7D:09(config)# vlan
AP-00:7D:09(config-vlan)# trunk-table
AP-00:7D:09(config-vlan-trunk)# rowadd 1 secondary-index 0 entry-status
create
AP-00:7D:09(config-vlan-trunk)# rowadd 1 secondary-index 0 trunk-id 10
AP-00:7D:09(config-vlan-trunk)# rowadd 1 secondary-index 0 entry-status
create
AP-00:7D:09# show vlan-trunk
// VLAN TRUNK TABLE CONFIGURATION //
INDEX 1.1
Trunk ID
: 10
Entry Status
: enable
Device Configuration, Management and Monitoring using CLI
: access
: 23
: 3
: disable
VLAN Mode of the interface
162