Proxim ORiNOCO AP-800 Installation And Management Manual page 172

Server Interface Table
To configure the DHCP Server Interface Table parameters, enter the following CLI commands.
DHCP Database
To view the DHCP Database, enter the following CLI commands.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09(config-dhcp)# server-interface-table
AP-00:7D:09(config-dhcp-serverif)# rowedit 1 ?
Possible completions:
<[Enter]>
default-gateway
default-leasetime
entry-status
net-mask
primary-dns
secondary-dns
AP-00:7D:09(config-dhcp-serverif)# rowedit 1 comment TestBox
AP-00:7D:09(config-dhcp-serverif)# rowedit 1 net-mask 255.255.255.0
AP-00:7D:09(config-dhcp-serverif)# rowedit 1 default-gateway 10.0.0.6
AP-00:7D:09(config-dhcp-serverif)# rowedit 1 primary-dns 10.0.0.200
AP-00:7D:09(config-dhcp-serverif)# rowedit 1 secondary-dns 10.0.0.200
AP-00:7D:09(config-dhcp-serverif)# rowedit 1 default-leasetime 3600
AP-00:7D:09(config-dhcp-serverif)# rowedit 1 entry-status 1
AP-00:7D:09(config-dhcp-serverif)# exit
AP-00:7D:09(config-dhcp)# exit
AP-00:7D:09(config)# exit
AP-00:7D:09# show dhcp server-interface-tbl
// DHCP SERVER INTERFACE TABLE CONFIGURATION //
INDEX 1
Interface Type : bridge
NetMask : 255.255.255.0
Default Gateway : 10.0.0.6
Primary DNS : 10.0.0.200
Secondary DNS : 10.0.0.200
Lease Time : 3600
Entry Status : enable
AP-B4:50:03# show dhcp-database
lease 192.168.8.178 {
starts 4 2011/09/22 17:14:26;
ends 4 2011/09/22 17:16 :26;
cltt 4 2011/09/22 17:14:26;
binding state free;
hardware ethernet 00:1d:7e:03:2b:d3;
uid "\001\000\035~\003+\323";
client-hostname "test1";
}
Device Configuration, Management and Monitoring using CLI
Execute this command
Default Gateway Configuration
Default Lease Time Configuration
Entry Status Configuration
Server Net Mask Configuration
Primary DNS Configuration
Seconday DNS Configuration
172