Telnet Configuration; Ssh Configuration - Proxim ORiNOCO AP-800 Installation And Management Manual

6.7.3 Telnet Configuration

To configure password, sessions, and port number for Telnet, enter the following CLI commands.
: To configure the Telnet access status as enable / disable, refer

6.7.4 SSH Configuration

To configure the sessions and port number for SSH, enter the following CLI commands.
: To configure the SSH access status as enable / disable, refer
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
AP-00:7D:09# configure
AP-00:7D:09(config)# management
AP-00:7D:09(config-mgmt)# telnet ?
Possible completions:
<[Enter]>
password
port
sessions
AP-00:7D:09(config-mgmt-tel)# password admin
Changes in telnet password requires reboot.
AP-00:7D:09(config-mgmt-tel)#port 123
Changes in telnet port requires reboot.
AP-00:7D:09(config-mgmt-tel)#sessions 2
Changes in telnet sessions requires reboot.
The sum of Telent and SSH sessions cannot be more than 3.
AP-00:7D:09(config-mgmt-tel)#exit
AP-00:7D:09(config-mgmt)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show telnet
// TELNET CONFIGURATION
Password : ******
Port : 123
Sessions : 2
AP-00:7D:09# configure
AP-00:7D:09(config)# management
AP-00:7D:09(config-mgmt)# ssh ?
Possible completions:
<[Enter]>
port
sessions
AP-00:7D:09(config-mgmt-ssh)# port 23
Changes in ssh port requires reboot.
AP-00:7D:09(config-mgmt-ssh)# sessions 1
Changes in ssh sessions requires reboot.
The sum of Telent and SSH sessions cannot be more than 3.
AP-00:7D:09(config-mgmt-ssh)#exit
AP-00:7D:09(config-mgmt)#exit
AP-00:7D:09(config)#exit
AP-00:7D:09# show ssh
// SSH CONFIGURATION //
SSH Port : 23
Sessions : 1
Device Configuration, Management and Monitoring using CLI
Access Control
Execute this command
Access password for the Telnet interface
<Characters ? " ' \ / = - space are not valid>
Configure the port on which the Telnet isaccessed
The number of telnet sessions.
//
Access Control
Execute this command
The port on which SSH is accessed
The number of concurrent SSH sessions
175