1. Configure the following parameters:
•
Pool Interface: Specifies the interface type (ethernet or wireless). The device supports only Bridge mode.
•
Start IP Address: See
•
End IP Address: See
•
Entry Status: Specifies the status of the pool entry being added. By default, it is enabled. To configure, select
Enable or Disable from the drop down menu.
2. Click Add, to save the added entry.
: You can add a maximum of five pool entries per interface.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
DHCP Pool Table
DHCP Pool Table
Device Configuration Using Web Interface
91