B Bootloader Cli And Scan Tool - Proxim ORiNOCO AP-800 Software Management Manual

Bootloader CLI and Scan Tool
The Bootloader CLI provides you the ability to configure the initial setup parameters as well as download a software image to
the device.
: For AP-8100, you can download the software image using ScanTool, as the Bootloader CLI mode (only accessible
through the serial interface) is not applicable to AP-8100.
This interface is only accessible through the serial interface, and used when:
•
The device does not contain a software image
•
An existing image is corrupted
•
An automatic (default) download of image over TFTP has failed
The Bootloader CLI supports the following commands.
•
factory_reset: Restores the factory settings
•
help: Prints online help
•
reboot: Reboots the device
•
set: Sets the parameters
•
show: Shows the parameters
The Bootloader CLI supports the following parameters (for viewing and modifying).
•
ipaddr: IP Address
•
systemname: System Name
•
gatewayip: Gateway IP Address
•
serverip: Server IP Address
•
ipaddrtype: IP Address Type
•
netmask: Net Mask
•
filename: Image file name (including the file extension)
If the Bootloader fails to load the firmware from flash, it tries to get the firmware from the network. While trying to get
firmware from the network, the device should be powered on by using ethernet interface. The default configuration of the
Bootloader parameters are as follows:
®
ORiNOCO 802.11n Access Points - Software Management Guide
Parameter
ipaddr 169.254.128.132
netmask 255.255.255.0
gatewayip 169.254.128.133
systemname systemname
serverip 169.254.128.133
filename imagename
ipaddrtype
Value
dynamic
B
158