Proxim ORiNOCO AP-800 Installation And Management Manual page 84

3.8.3.1 Advanced Filter table
Advance Filter Table contains a list of all protocols on which Advanced Filtering is applied.
1. Protocol Name: Specifies the protocol name that is to be filtered. By default, Advanced Filters are supported on the
following five default protocols:
— Deny-IPX-RIP
— Deny-IPX-SAP
— Deny-IPX-LSP
— Deny-IP-Broadcasts
— Deny-IP-Multicasts
2. Direction: Specifies the direction of an IP Protocol traffic. The direction can be enabled either for ethernet to wireless,
wireless to ethernet or both ways.
3. Entry Status: Specifies the status of the filter applied on the IP Protocol.
4. To edit any protocol entry, click Edit. The Advanced Filters - Edit Entries screen appears.
5. Modify the Direction and Status of the desired IP Protocol.
6. Click OK, to save the configured parameters.
ORiNOCO® AP-800 and AP-8000 Installation and Management Guide
Figure 3-43 Advanced Filters - Edit Entries
Device Configuration Using Web Interface
84